•
Your PC terminal emulation program is configured for 9600 baud, 8 data bits, 1 stop bit, no parity, and
flow control is set to none.
•
You have selected passwords for access control.
•
Captive installation screws are tight on all removable components.
•
The console terminal is turned on.
•
You have determined the IP addresses for the Ethernet and serial interfaces.
•
Empty card slots or card bays are filled with card blanks. This ensures proper air flow through the chassis
and electromagnetic compatibility (EMC).
You are now ready to start your router.
Verifying Power Supply Operation
Follow this procedure to verify power supply is operating correctly.
SUMMARY STEPS
1.
Check that the power supply LEDs are:
2.
To ensure that the power supply state is OK, type the show platform command. This output sample is
from the Cisco ASR 1013 router. The other Cisco ASR 1000 routers display similar type of output.
DETAILED STEPS
Step 1
Check that the power supply LEDs are:
•
INPUT OK is green
•
FAN OK is green
•
OUTPUT FAILED is not illuminated
Step 2
To ensure that the power supply state is OK, type the show platform command. This output sample is from the Cisco
ASR 1013 router. The other Cisco ASR 1000 routers display similar type of output.
The following output displays:
Example:
Router# show platform
Chassis type: ASR1013
Slot Type State Insert time (ago)
--------- ------------------- --------------------- -----------------
0 ASR1000-SIP40 ok 22:56:46
0/0 SPA-5X1GE-V2 ok 22:55:42
0/1 SPA-5X1GE-V2 ok 22:55:36
0/2 SPA-5X1GE-V2 ok 22:55:32
0/3 SPA-5X1GE-V2 ok 22:55:28
1 ASR1000-SIP40 ok 22:56:46
1/0 SPA-5X1GE-V2 ok 22:55:43
1/1 SPA-5X1GE-V2 ok 22:55:40
1/2 SPA-5X1GE-V2 ok 22:55:35
Cisco ASR 1000 Series Router Hardware Installation Guide
462
Cisco ASR 1000 Series Routers Power Up and Initial Configuration
Verifying Power Supply Operation
To Next Page
Loading...
Need help?
General
