Cisco ASR 1004 Hardware Installation Guide

Step 2
Insert the other end of the RJ-45 cable to your management device or network.
Cisco ASR 1002 Router Power Supplies
This section describes the Cisco ASR 1002 Router power supplies and how to connect them:
Read the safety warnings before you begin.
The covers are an integral part of the safety design of the product. Do not operate the unit without the
covers installed. Statement 1077
Warning
When you install the unit, the ground connection must always be made first and disconnected last. Statement
1046
Warning
Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Statement 1003
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning
Never install an AC power module and a DC power module in the same chassis. Statement 1050Warning
Installation of the equipment must comply with local and national electrical codes. Statement 1074Warning
When installing or replacing the unit, the ground connection must always be made first and disconnected
last. Statement 1046
Warning
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority
or an electrician if you are uncertain that suitable grounding is available. Statement 1024
Warning
Cisco ASR 1000 Series Router Hardware Installation Guide
255
Cisco ASR 1002 Router Overview and Installation
Cisco ASR 1002 Router Power Supplies

Cisco ASR 1004 Specifications

General

Brand	Cisco
Model	ASR 1004
Category	Network Router
Language	English