Cisco ASR 1004 Hardware Installation Guide

•
The Cisco ASR 1002-F Router needs adequate ventilation. Do not install it in an enclosed cabinet where
ventilation is inadequate.
•
Have the cable-management bracket available if you plan to install it on the front of the chassis.
•
An adequate chassis ground (earth) connection exists for your router chassis
(see the Attaching a Chassis Ground Connection, on page 302).
•
Always follow proper lifting practices as outlined in the next section, when handling the chassis.
Equipment Shelf or Tabletop Installation
To mount your Cisco ASR 1002-F Router on an equipment shelf or tabletop, follow these steps:
SUMMARY STEPS
1.
Remove any debris and dust from the tabletop or platform, as well as the surrounding area.
2.
Lift the chassis into position on the equipment shelf or tabletop. image shows how to lift the chassis.
3.
Attach the front rack-mount brackets. Locate the threaded holes in the front sides of the chassis (first holes
beyond the vent holes) and use the package of black screws that shipped with the chassis.
4.
Align the front rack-mount bracket to one side of the chassis.
5.
Insert and tighten the screws on one side.
6.
Repeat Step 4 through Step 5 on the other side of the chassis. Use all the screws to secure the rack-mount
brackets to the chassis.
7.
Gather the two cable-management brackets and screws that shipped with your chassis. The following
image shows cable-management brackets attached on the front of the Cisco ASR 1002-F Router.
8.
Screw the cable-management brackets to each side of the rack-mount brackets already attached to the
chassis. Use two screws for each cable-management bracket.
9.
Check that all the screws are securely tightened.
DETAILED STEPS
Step 1
Remove any debris and dust from the tabletop or platform, as well as the surrounding area.
Step 2
Lift the chassis into position on the equipment shelf or tabletop. image shows how to lift the chassis.
Cisco ASR 1000 Series Router Hardware Installation Guide
289
Cisco ASR 1002-F Router Overview and Installation
Equipment Shelf or Tabletop Installation

Cisco ASR 1004 Specifications

General

Product Type	Router
Form Factor	Rack-mountable
Rack Height	2U
Forwarding Capacity	Up to 20 Gbps
Total Number of Ports	Varies by configuration
Number of Total Expansion Slots	4
Product Series	ASR 1000
Model	ASR 1004
Forwarding Performance	Up to 20 Gbps
Operating System	Cisco IOS XE
Power Supply	Dual
Route Processor	ASR 1000 Series Route Processor
Network Interface Modules	SFP, SFP+, Gigabit Ethernet, 10 Gigabit Ethernet
Interfaces/Ports	Varies by configuration
Expansion Slot Type	SPA
Throughput	20 Gbps
Redundancy	Power supply, Route Processor
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet, SFP, SFP+
Storage	Up to 64 GB Flash