Cisco ASR 1004 Hardware Installation Guide

Replacing the Cisco ASR1000-RP1 Internal Hard Drive
To replace the Cisco ASR1000-RP1 internal hard drive and insert the Cisco ASR 1000 Series Route Processor
1 into the Cisco ASR 1000 Series Router, follow these steps:
SUMMARY STEPS
1.
On the Cisco ASR1000-RP1, carefully align the new hard drive unit with its screw fastener to the base
screw on the bottom of the module.
2.
Reconnect the two cables to the rear of the hard drive. These are keyed for easy connection.
3.
Align hard drive module to carrier base tabs, align the module fastener to base screw mate by hand, and
then tighten with screw driver.
4.
Replace the cover by aligning the tabs in the slot and tightening the screw fasteners.
5.
With two hands, grab the handles on the Cisco ASR1000-RP1 module and slide it back into its slot in the
Cisco ASR 1000 Series Router and tighten the captive screw.
DETAILED STEPS
Step 1
On the Cisco ASR1000-RP1, carefully align the new hard drive unit with its screw fastener to the base screw on the
bottom of the module.
Step 2
Reconnect the two cables to the rear of the hard drive. These are keyed for easy connection.
Cisco ASR 1000 Series Router Hardware Installation Guide
482
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
Removing and Replacing the Cisco ASR1000-RP1 Module Internal Hard Drive

Cisco ASR 1004 Specifications

General

Product Type	Router
Form Factor	Rack-mountable
Rack Height	2U
Forwarding Capacity	Up to 20 Gbps
Total Number of Ports	Varies by configuration
Number of Total Expansion Slots	4
Product Series	ASR 1000
Model	ASR 1004
Forwarding Performance	Up to 20 Gbps
Operating System	Cisco IOS XE
Power Supply	Dual
Route Processor	ASR 1000 Series Route Processor
Network Interface Modules	SFP, SFP+, Gigabit Ethernet, 10 Gigabit Ethernet
Interfaces/Ports	Varies by configuration
Expansion Slot Type	SPA
Throughput	20 Gbps
Redundancy	Power supply, Route Processor
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet, SFP, SFP+
Storage	Up to 64 GB Flash