Cisco ASR 1004 Hardware Installation Guide

CHAPTER 13
Cisco ASR 1000 Series Routers Power Up and
Initial Configuration
This chapter guides you through a basic router configuration, which is sufficient for you to access your
network. Complex configuration procedures are beyond the scope of this publication and can be found in
the modular configuration and modular command reference publications in the Cisco IOS software
configuration documentation set that corresponds to the software release installed on your Cisco hardware.
To configure the Cisco ASR 1000 Series Router from a console, you need to connect a terminal to the router
console port.
This chapter contains the following sections:
•
Checking Conditions Prior to System Startup, page 461
•
Verifying Power Supply Operation, page 462
•
Powering Up the Cisco ASR 1000 Series Routers, page 463
•
Configuring the Cisco ASR 1000 Series Routers at Startup, page 467
•
Powering Off the Cisco ASR 1000 Series Router Safely, page 470
Checking Conditions Prior to System Startup
Ensure that the following conditions are addressed before starting up the router:
•
The shared port adapter is inserted in its slot.
•
The network interface cable is connected.
•
The optional Fast Ethernet Management port cable is installed.
•
The chassis is securely mounted and grounded.
•
The power and interface cables are connected
.
•
Your PC with terminal emulation program (hyperTerminal or equivalent) is connected to the console
port and powered up.
Cisco ASR 1000 Series Router Hardware Installation Guide
461

Cisco ASR 1004 Specifications

General

Product Type	Router
Form Factor	Rack-mountable
Rack Height	2U
Forwarding Capacity	Up to 20 Gbps
Total Number of Ports	Varies by configuration
Number of Total Expansion Slots	4
Product Series	ASR 1000
Model	ASR 1004
Forwarding Performance	Up to 20 Gbps
Operating System	Cisco IOS XE
Power Supply	Dual
Route Processor	ASR 1000 Series Route Processor
Network Interface Modules	SFP, SFP+, Gigabit Ethernet, 10 Gigabit Ethernet
Interfaces/Ports	Varies by configuration
Expansion Slot Type	SPA
Throughput	20 Gbps
Redundancy	Power supply, Route Processor
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet, SFP, SFP+
Storage	Up to 64 GB Flash