Cisco ASR 1004 Hardware Installation Guide

Change SummaryDate
Added information about the Cisco ASR 1002-F
Router.
Unless otherwise noted, the Cisco ASR
1002-F Router supports all the
general-purpose routing and security features
of the Cisco ASR 1002 Router and uses the
same internal control and data-plane
architecture as Cisco ASR 1002 Router and
the Cisco ASR 1002-F Router is supported
only by Cisco software release four code.
Note
June 2009
Added information about Cisco ASR1000-RP2 and
how alarms work with the power supply DB-25
connector. In addition, added safety information and
updated the chapter on field-replaceable units (FRUs).
February 2009
Added information about the improved window of
time allotted to replace a power supply. You now
have up to 5 minutes to replace the power supply.
November 2008
Added information about Cisco ASR1000-ESP20 and
Cisco ASR1000-ESP10-N support. Updated eUSB
device graphics and replacement information.
October 2008
Released the first version of this document for the
Cisco ASR 1000 Series Routers.
May 2008
Document Objectives
This publication describes the installation of the Cisco ASR 1000 Series Aggregation Services Routers,
replacement or upgrading of field-replaceable units (FRUs), and troubleshooting of the Cisco ASR 1000
Series Routers hardware. The purpose of this guide is to enable the safe and efficient installation of the Cisco
ASR 1000 Series Aggregation Services Routers.
For information on installation of the Cisco ASR 1001-X Router, and replacement or upgrading of its
field-replaceable units (FRUs), see the Cisco ASR 1001-X Router Hardware Installation Guide at the
following URL: http://www.cisco.com/c/en/us/td/docs/routers/asr1000/install/guide/1001-x/asr1hig.html.
Note
Audience
This publication is primarily designed for the person responsible for installing, maintaining, and troubleshooting
the Cisco ASR 1000 Series Aggregation Services Routers. The users of this guide should:
•
Be familiar with electronic circuitry and wiring practices.
Cisco ASR 1000 Series Router Hardware Installation Guide
xxiii
Preface
Document Objectives

Cisco ASR 1004 Specifications

General

Product Type	Router
Form Factor	Rack-mountable
Rack Height	2U
Forwarding Capacity	Up to 20 Gbps
Total Number of Ports	Varies by configuration
Number of Total Expansion Slots	4
Product Series	ASR 1000
Model	ASR 1004
Forwarding Performance	Up to 20 Gbps
Operating System	Cisco IOS XE
Power Supply	Dual
Route Processor	ASR 1000 Series Route Processor
Network Interface Modules	SFP, SFP+, Gigabit Ethernet, 10 Gigabit Ethernet
Interfaces/Ports	Varies by configuration
Expansion Slot Type	SPA
Throughput	20 Gbps
Redundancy	Power supply, Route Processor
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet, SFP, SFP+
Storage	Up to 64 GB Flash