Cisco ASR 1004 Hardware Installation Guide

Step 3
After you establish normal router operation, you can disconnect the console terminal.
What to Do Next
A connection will not be established when setting up an out-of-band connection or modem connection in
the auxiliary port and the console port.
Note
Connecting a Cable to the Management Ethernet Port
This section describes how to attach a cable to the Cisco Management Ethernet port on the Cisco ASR 1002-F
Router.
Step 1
Insert an Ethernet RJ-45 cable into the MGMT ETHERNET port (see ).
Figure 136: Cisco ASR 1002-F Router Integrated RP Management Ethernet Port Connector
Management Ethernet port1
Step 2
Insert the other end of the RJ-45 cable into your management device or network.
Step 3
Configure the port connection to a fixed speed through the command-line interface (CLI).
Connecting Power to the Cisco ASR 1002-F Router
The covers are an integral part of the safety design of the product. Do not operate the unit without the
covers installed in empty slots. Statement 1077
Warning
When you install the unit, the ground connection must always be made first and disconnected last. Statement
1046
Warning
Cisco ASR 1000 Series Router Hardware Installation Guide
306
Cisco ASR 1002-F Router Overview and Installation
Connecting a Cable to the Management Ethernet Port

Cisco ASR 1004 Specifications

General

Product Type	Router
Form Factor	Rack-mountable
Rack Height	2U
Forwarding Capacity	Up to 20 Gbps
Total Number of Ports	Varies by configuration
Number of Total Expansion Slots	4
Product Series	ASR 1000
Model	ASR 1004
Forwarding Performance	Up to 20 Gbps
Operating System	Cisco IOS XE
Power Supply	Dual
Route Processor	ASR 1000 Series Route Processor
Network Interface Modules	SFP, SFP+, Gigabit Ethernet, 10 Gigabit Ethernet
Interfaces/Ports	Varies by configuration
Expansion Slot Type	SPA
Throughput	20 Gbps
Redundancy	Power supply, Route Processor
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet, SFP, SFP+
Storage	Up to 64 GB Flash