Cisco ASR 1004 Hardware Installation Guide

Removing and Replacing the Cisco ASR1000-RP2 Module Internal Hard Drive
This section explains how to remove a hard drive assembly from the Cisco ASR 1000 Series RP2 module and
replace it with a new internal hard drive.
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94
Warning
Before you begin, read the following important notices:
•
The form-factor internal hard drive is accessible from the front panel of the Cisco ASR1000-RP2 and
supports the online insertion and removal feature (OIR) using the following CLI commands for the
standby and active RP2:
◦
request platform hardware filesystem harddisk: offline (Unmounts the hard disk on the active
RP2.)
◦
request platform hardware filesystem harddisk: online (Mounts the hard disk on the active
RP2.) If the disk is not provisioned properly, this command will provision the disk.
◦
request platform hardware filesystem stby-harddisk: offline (Unmounts the hard disk on the
standby RP2.)
◦
request platform hardware filesystem stby-harddisk: online (Mounts the hard disk on the
standby RP2. If the disk is not provisioned properly, this command will provision the disk.)
•
The reason you would be removing an internal hard drive is that it is failing or failed; so any data recovery
may be lost.
•
If the drive is functioning, you can back it up to a drive plugged into a USB port using the archive tar
command.
Removing the Cisco ASR1000-RP2 Internal Hard Drive
To remove the Cisco ASR1000-RP2 internal hard drive from the Cisco ASR 1006 Router and Cisco ASR
1004 Router, follow this procedure:
SUMMARY STEPS
1.
Run the request platform hardware filesystem harddisk: offline command.
2.
Slip on an ESD-preventive wrist strap.
3.
From the front panel of the Cisco ASR1000-RP2, unscrew the fastener screw (see the following figure).
4.
Pull the internal hard drive out as shown in the following figure.
5.
Place the component in an antistatic bag if you are returning it.
6.
Wait until the following console message is displayed:
Cisco ASR 1000 Series Router Hardware Installation Guide
484
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
Removing and Replacing the Cisco ASR1000-RP2 Module Internal Hard Drive

Cisco ASR 1004 Specifications

General

Product Type	Router
Form Factor	Rack-mountable
Rack Height	2U
Forwarding Capacity	Up to 20 Gbps
Total Number of Ports	Varies by configuration
Number of Total Expansion Slots	4
Product Series	ASR 1000
Model	ASR 1004
Forwarding Performance	Up to 20 Gbps
Operating System	Cisco IOS XE
Power Supply	Dual
Route Processor	ASR 1000 Series Route Processor
Network Interface Modules	SFP, SFP+, Gigabit Ethernet, 10 Gigabit Ethernet
Interfaces/Ports	Varies by configuration
Expansion Slot Type	SPA
Throughput	20 Gbps
Redundancy	Power supply, Route Processor
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet, SFP, SFP+
Storage	Up to 64 GB Flash