SUMMARY STEPS
1.
Slip on the ESD-preventive wrist strap that was included in the accessory kit.
2.
Enter the reload command.
3.
Confirm the reload command.
4.
After confirming the reload command, wait until the system bootstrap message displays before powering
off the system.
5.
Remove any power cables from the Cisco ASR 1000 Series Router.
DETAILED STEPS
Step 1
Slip on the ESD-preventive wrist strap that was included in the accessory kit.
Step 2
Enter the reload command.
Step 3
Confirm the reload command.
Example:
Router# reload
Proceed with reload? [confirm]
Aug 17 00:06:47.051 R0/0: %PMAN-5-EXITACTION: Process manager is exiting: prs exit with reload chassis
code
Step 4
After confirming the reload command, wait until the system bootstrap message displays before powering off the system.
Example:
System Bootstrap, Version 12.2(33r)XN2, RELEASE SOFTWARE (fc1)
Technical Support: tap://www.cisco.com/techsupport
Copyright (c) 2008 by cisco Systems, Inc.
Current image running: Boot ROM0
Last reset cause: LocalSoft
ASR1000-RP1 platform with 4194303 Kbytes of main memory
mcp-6ru-1-rp0-rommon 1>
Step 5
Remove any power cables from the Cisco ASR 1000 Series Router.
a) For power supplies with a circuit breaker switch, position the switch to the Off (O) position.
b) For power supplies with a Standby switch, place the Standby switch in the Standby position.
After powering off the router, wait a minimum of 30 seconds before powering it on again.Note
Cisco ASR 1000 Series Router Hardware Installation Guide
471
Cisco ASR 1000 Series Routers Power Up and Initial Configuration
Powering Off the Cisco ASR 1000 Series Router Safely
To Next Page
Loading...
Need help?
General
