OPERATING THE TRANSCEIVER
CALLING
54 ENVOY™ TRANSCEIVER REFERENCE MANUAL
1 If you do not want to use the HF network shown at the top right of the screen:
•Press (Options).
• Scroll to HF Networks, then press (Select).
• Scroll to the HF network that you want to use, then press OK.
1 Press or to select the Message call type if it is not selected.
1 Do one of the following:
• To repeat the call to the last address used, press CALL.
• To call a different station, enter the address, then press CALL.
• To repeat or return a call from the Call Log, press to scroll to the call,
press or to select your required call type, then press CALL.
• To use an ALE address syntax in an ALE/CALM HF network, press
(View), scroll to ALE, press (Select), scroll to the syntax that you
want to use, then press CALL.
1 If you want to enter a message:
• Start typing the message.
NOTE: Press OK to start a new line, if required.
•Press (Options), scroll to OK, then press (Select) to add the
message to the call.
To Next Page
Loading...
Need help?
General
