Comtech EF Data CDM-625 - Page 501

CDM-625 Advanced Satellite Modem Revision 13
Appendix D MN-CDM625
D–31
Parameter
Type
Command
(Instruction
& Qualifier)
Number of
Arguments
Description of Arguments
Response to
Command
Query
(Instruction &
Qualifier)
Response to
Query
Number of
Unread
stored Events
N/A
3 bytes
Query only.
Unit returns the Number of stored Events, which remain Unread, (over remote control) in the form xxx (0-255).
Example: NUE=126
N/A
NUE?
NUE=xxx
(see Description of
Arguments)
Retrieve next
5 unread
Stored
Events
N/A
80 bytes
Query only.
Unit returns the oldest 5 Stored Events which have not yet been read over the remote control in the reply
format
[CR]sub-body[CR]sub-body[CR]sub-body[CR]sub-body[CR]sub-body, where:
sub-body=ABCddmmyyhhmmss, where:
A is the fault/clear indicator:
F=Fault
C=Clear
I=Info
B is the fault type where:
1=Unit
2=Rx Traffic
3=Tx Traffic
4=Info (Power on/off, or log cleared)
5=Open Network
6=BUC
7=LNB
C is Fault Code number, as in FLT? or Info Code, which may be:
0=Power Off
1=Power On
2=Log Cleared
3=Global Config Change
4=Redundancy Config Change
5=Fractional CnC License is expiring.
6=Time Limited CnC License is expiring.
7=Fractional CnC is in use.
ddmmyy = date stamp.
hhmmss = time stamp.
If there are less than 5 events to be retrieved, the remaining positions are padded with zeros. If there are no
new events, the response is RNE*.
N/A
RNE?
RNE=[CR]ABCddm
myyhhmmss[CR]A
BCddmmyyhhmms
s[CR]ABCddmmyyh
hmmss[CR]ABCdd
mmyyhhmmss[CR]
ABCddmmyyhhmm
ss
(see Description of
Arguments)
Clear All
Stored
Events
CAE=
None
Command only.
Forces the software to clear the software events log.
Note: This command takes no arguments
Example: CAE=
CAE=
CAE?
CAE*
CAE#
N/A
N/A