CDM-625 Advanced Satellite Modem Revision 13
Appendix D MN-CDM625
D–57
D.5.8 BUC Parameters (L-Band Device)
Parameter
Type
Number of
Arguments
Description of Arguments
Response to
Command
Exception –
600L Emulation:
BUC Power Supply control in the form x. where:
0 = Disable the BUC DC Power Supply
1 = Enable the BUC DC Power Supply
Exception –
600L Emulation:
(see Description of
Arguments)
Exception –
600L Emulation:
ODR=
In the form x, where:
0 = OFF
1 = ON
Exception –
600L Emulation:
ODR?
(see Description of
Arguments)
Exception –
600L Emulation:
BUC Current Low Limit, in the form xxxx, where xxxx is a value between 0 and 4000mA, in 100mA
increments.
Exception –
600L Emulation:
(see Description of
Arguments)
Exception –
600L Emulation:
BUC Current High Limit, in the form xxxx, where xxxx is a value between 0 and 4000mA, in 100mA
increments.
Exception –
600L Emulation:
(see Description of
Arguments)
Exception –
600L Emulation:
BUC Address, in the form xx, where xx is a value between 1 and 15.
Note: This command is only valid when the FSK is enabled.
Exception –
600L Emulation:
(see Description of
Arguments)
Exception –
600L Emulation:
OOP=
BUC Tx Carrier Output Power Enable in the form x, where:
0 = OFF
1 = ON
Note: This command is only valid when the FSK is enabled.
Exception –
600L Emulation:
OOP?
(see Description of
Arguments)
BUC DC current, in the form xxxx, where xxxx is a value between 0 and 9999, units mA.
If not available, response is 0000.
Exception –
600L Emulation:
(see Description of
Arguments)
BUC Voltage, in the form xx.x, where xx.x is a value between 0 and 64.0, units in volts.
Exception –
600L Emulation:
(see Description of
Arguments)
BUC Output Power Level, in the form xx.x, where xx.x is the value in dBm.
Returns xxxx when FSK is not enabled.
Exception –
600L Emulation:
OOL?
(see Description of
Arguments)
To Next Page
Loading...
