Enter/Exit Programming Mode 2D Symbology Programming
438 Magellan™ 9300i / 9400i Scanners
QR Code Length 1, Length 2 Programming Instructions
If QR Code Length Control is set to Fixed-Length decoding, this feature speci-
fies QR Code first fixed length. If QR Code Length Control is set to Variable-
Length decoding, this feature specifies the minimum label length.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan the bar code, Set QR Code Length 1 on page 438 or Set QR Code
Length 2 on page 438 below. You’ll need to cover any unused bar codes
on this and the facing page to ensure that the scanner reads only the bar
code you intend to scan.
3. Scan the appropriate digits from the Keypad on page 461 in Appendix C
that represent the desired label length. The selectable range for this
option is 0001 to 2710. Pad all numbers with leading zeros to yield a four-
digit entry (001-02710).
4. Complete the programming sequence by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
NOTE
Length 1 is the minimum label length if in variable
length mode, or the first fixed length if in fixed length
mode. Length 2 is the maximum label length if in vari
-
able length mode, or the second fixed length if in fixed
length mode. Length includes the bar code's data char
-
acters only. Any value > 2710 will be considered to be
2710.
Default setting for this feature = 0001
Set QR Code Length 1
Set QR Code Length 2
Default setting for this feature = 0A96
To Next Page
Loading...
