Enter/Exit Programming Mode 2D Symbology Programming
446 Magellan™ 9300i / 9400i Scanners
Aztec Length 1, Length 2 Programming Instructions
If Aztec Length Control is set to Fixed-Length decoding, this feature specifies
Aztec first fixed length. If Aztec Length Control is set to Variable-Length
decoding, this feature specifies the minimum label length.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan the bar code, Set Aztec Length 1 on page 446 or Set Aztec Length 2
on page 446 below. You’ll need to cover any unused bar codes on this and
the facing page to ensure that the scanner reads only the bar code you
intend to scan.
3. Scan the appropriate digits from the Keypad on page 461 in Appendix C
that represent the desired label length. The selectable range for this
option is 0001 to 3700. Pad all numbers with leading zeros to yield a four-
digit entry (0001-3700).
4. Complete the programming sequence by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
NOTE
Length 1 is the minimum label length if in variable length mode, or
the first fixed length if in fixed length mode. Length 2 is the maxi
-
mum label length if in variable length mode, or the second fixed
length if in fixed length mode. Length includes the bar code's data
characters only. Any value > 3700 will be considered to be 3700.
Default setting for this feature = 0001
Set Aztec Length 1
Set Aztec Length 2
Default setting for this feature = 0E74
To Next Page
Loading...
