498 Magellan™ 9300i / 9400i Scanners
EAN8 with Code128 Supplemental
• Check digit must be included in label data and is assumed to be correct
• Supplemental data is appended to base label
• Prefix must be an ASCII characters ‘FF’ - total length including prefix must
be greater than 16 (code 128 supplemental codes are variable length hav
-
ing a minimum of 2 data characters)
• Characters immediately following base label must be of the form ‘8100’,
‘8101’ or ‘8102’
• Example: ‘FF002101268102000951’
EAN13
• Check digit must be included in label data and is assumed to be correct
• Prefix must be an ASCII character ‘F’- total length including prefix must be
14
• Example: ‘F1101234567891’
EAN13 with 2-Digit Supplemental
• Check digit must be included in label data and is assumed to be correct
• Supplemental data is appended to base label
• Prefix must be an ASCII character ‘F’- total length including prefix must be
16
• Example: ‘F110123456789112’
EAN13 with 5-Digit Supplemental
• Check digit must be included in label data and is assumed to be correct
• Prefix must be an ASCII character ‘F’- total length including prefix must be
19
• Example: ‘F110123456789112345’
EAN13 with Code128 Supplemental
• Check digit must be included in label data and is assumed to be correct
• Supplemental data is appended to base label
• Prefix must be an ASCII character ‘F’- total length including prefix must be
greater or equal to 20 (code 128 supplemental codes are variable length
having a minimum of 2 data characters)
• Characters immediately following base label must be of the form ‘8100’, ‘8101’ or
‘8102’
• Example: ‘F11012345678918100000951’
Code 39
• Check character must be included in label data
• Label length including start, stop and check characters and excluding pre-
fix character must meet requirements imposed by the main scanner’s
fixed or variable label length control for this symbology type.
• Start and stop characters “*” must be included in label
• Prefix must be an ASCII character ‘*’
• Example : ‘**CODE39.TEST*’