Dodge Sprinter 2006 - Page 1695

(5) Pull module assembly up just a few inches to
gain access to float support arm/r od (3) (F ig. 12). Be
carefu l not to ben d float support r od while r emoving
pu mp module.
(6) Rotat e clip (2) (Fig. 13) to release float rod (3)
from fuel level sensor (1).
(7) Twist rod (3) slight ly (Fig. 14) to remove from
fuel level sensor. Do not allow float assembly to fall
into fuel tan k.
(8) While holdin g float rod, remove fuel pump
module from fuel ta nk.
(9) Remove floa t assembly from fu el ta nk.
(10) Remove and disca rd r ubber gasket (seal) from
pu mp module.
Fig. 11 FUEL PUMP MODULE R/I
1 - LOCKNUT (LOCKRING)
2 - SPECIAL TOOL #6856
3 - TOP OF PUMP MODULE
Fig. 12 FLOAT ROD CLIP
1 - FUEL LEVEL SENSOR
2 - CLIP
3 - FLOAT ROD
Fig. 13 FLOAT ROD CLIP REMOVAL
1 - FUEL LEVEL SENSOR
2 - CLIP
3 - FLOAT ROD
Fig. 14 FLOAT ROD CLIP REMOVED
1 - FUEL LEVEL SENSOR
2 - CLIP
3 - FLOAT ROD
VA FUEL DELIVERY 14 - 19