(4) Remove carrier pla te bolts. (Fig. 27)
(5) Disengage lift arm fr om glass guide rail a nd
remove regulator a ssem bly. (Fig. 28)
(6) Remove four r ivet s atta chin g r egulator t o car-
rier plate and r emove regu lat or. (Fig. 29)
INSTALLATION
(1) In st all regulator on to ca rrier pla te an d insta ll
new rivets.
(2) In st all regu lator lift ar m into gla ss guide rail
and install regulator a ssem bly.
(3) In st all ca rrier bolts and tighten to 10 N·m (89
in. lbs.).
(4) Remove glass support.
(5) Connect batt ery n egat ive cable.
(6) Verify correct win dow operat ion.
(7) In st all t rim pa nel. (Refer to 23 - BODY/DOOR -
FRONT/TRIM PANE L - INSTALLATION)
Fig. 26 GLASS SUPPORT
1 - WOOD WEDGE (or equivalent)
2 - WINDOW GLASS
Fig. 27 MANUAL REGULATOR ASSEMBLY
1 - DOOR
2 - CARRIER PLATE BOLTS
3 - CARRIER PLATE
4 - REGULATOR ASSEMBLY
5 - SEALING STRIP
6 - REGULATOR RIVETS (4)
7 - WINDOW CRANK/TRIM RING
8 - TRIM PANEL
9 - CLIPS
10 - WINDOW FRAME MOLDING
11 - REGULATOR
Fig. 28 LIFT ARM
1 - GLASS GUIDE RAIL
2 - LIFT ARM
Fig. 29 MANUAL REGULATOR FASTENERS
1 - RIVETS (4)
2 - REGULATOR
3 - CARRIER PLATE
23 - 22 D OOR - F R ON T VA
To Next Page
Loading...
