Dodge Sprinter 2006 - Page 1972

INSTALLATION
(1) Connect electrical conn ectors a nd cable to latch
assembly.
(2) In st all latch in door and insta ll screws.
(3) Connect lock rod.
(4) In st all r igh t side trim panel. (Refer to 23 -
BODY/DOORS - REAR/TRIM PANE L - INSTALLA-
TION )
(5) Connect batt ery n egat ive cable.
TRIM PANEL
REMOVAL
(1) Remove trim an d in terior handle, if equipped
(Fig. 21). (Refer t o 23 - BODY/DOORS - REAR/IN-
SIDE H ANDLE ACTUATOR - REMOVAL)
(2) Remove push pin fast eners, if equ ipped.
(3) Usin g a trim st ick C-4755 or equ iva lent ,
remove th e lower t rim pan el.
(4) Remove rivets and remove u pper trim pan el, if
equ ipped .
INSTALLATION
(1) In st all upper tr im panel an d r eplace rivets.
(2) In st all lower trim and install pu sh pin fasten-
er s, if equ ipped .
(3) In st all interior ha ndle, i f equipped. (Refer t o 23
- BODY/DOORS - REAR/INSIDE HANDLE ACTUA-
TOR - INSTALLATION)
Fig. 20 LATCH
1 - DOOR LOCK KNOB
2 - ELECTRIC
3 - CABLE
4 - LOCK ROD
5 - LATCH ASSEMBLY
6 - ELECTRICAL CONNECTORS ROUTING
7 - SCREWS (3)
Fig. 21 TRIM PANEL
1 - TRIM
2 - INSIDE HANDLE ACTUATOR
3 - TRIM PANEL
4 - CONTROL CABLE
23 - 34 D OOR S - R EAR VA