INSTALLATION
(1) Position roller ar m in guide track.
(2) In st all arm into door openin g an d lin e up tab
with m arks made pr eviously.
(3) In st all bolt a nd tighten t o 45 N·m (33 ft. lbs.).
(4) In st all rubber cover.
(5) Adjust door if necessa ry. (Refer to 23 - BODY/
DOORS - SLIDING/SLIDING DOOR - ADJ UST-
ME N TS)
(6) In st all trim panel if necessa ry. (Refer to 23 -
BODY/DOORS - SLIDING/TRIM PANE L - INSTAL-
LATION )
(7) In st all trim cover.
LOWER ROLLER ARM
REMOVAL
(1) Remove trim plugs a nd screws and remove
st epwell scuff pad. (Fig. 5)
(2) Remove the door scr ews a nd remove the roller
arm. (Fig. 6)
INSTALLATION
(1) In st all roller ar m and in st all door screws.
(2) Tighten screws to 25 N·m (18 ft. lbs.).
(3) In st all stepwell scuff pa d a nd install screws.
(4) Adjust door if necessa ry. (Refer to 23 - BODY/
DOORS - SLIDING/SLIDING DOOR - ADJ UST-
ME N TS)
CEN T ER T RACK
REMOVAL
(1) Remove cen ter roller arm. (Refer to 23 - BODY/
DOORS - SLIDING/CENTER ROLLER ARM -
REMOVAL)
Fig. 4 CENTER ROLLER ARM
1 - TRIM COVER
2 - SLIDING DOOR
3 - CENTER ROLLER ARM RUBBER COVER
4 - CENTER ROLLER ARM
5 - BOLT
Fig. 5 SLIDING DOOR SCUFF PAD
1 - TRIM PLUGS
2 - SCREWS (5)
3 - SCUFF PAD
Fig. 6 SLIDING DOOR LOWER ROLLER ARM
1 - SCREWS
2 - ROLLER ARM
VA DOORS - SLIDING 23 - 37
To Next Page
Loading...
