TE S T ACTION AP PLICAB ILITY
1 NOTE: If the ECM detects and stores a DTC, the ECM also stores the
e n gi n e /ve h ic le o p e ra ti n g c o n d i tio n s u n d e r w h ic h th e D TC w a s s e t. S o m e o f
these conditions are displayed on the DRB at the same time the DTC is
displayed.
NOTE: Before erasing stored DTCs, record these conditions. Attempting to
duplicate these conditions may assist when checking for an active DTC.
NOTE: This code was set in the ECM by the Transmission Control Module to
indicate a transmission fault. Diagnosis of transm ission faults should be
done using the Transmission Diagnostic Information.
NOTE: When repairs have been completed, the ECM and TCM must have
codes cleared.
Tur n th e ign it ion on .
Wit h th e DRBIII", er a se E CM DTCs only.
Wit h th e DRBIII",readECMDTCs.
Are t h ere a n y TCM DTCs pr esen t in th e ECM?
All
Ye s → Refer t o Tr a n sm ission Dia gn ost ic In for m a t ion for t h e rela t ed
sym pt om (s).
Per for m N AG1 TRAN SMISSION VE RIF ICATION TE ST - VER 1.
No → Test Com plet e.
189
DRI V EABI LI T Y - DI ESEL
P 2217-TCM D TC IN TERNAL FAU LT P RES EN T — Co nt inued
To Next Page