NOTE: If center bearing is equipped with a round
flange install new bolt in middle of the flange and
tighten to 95 N·m (70 ft. bls.).
(2) In st all snap-ring.
(3) Coat propeller shaft splin e with universal
gre as e.
(4) Push ru bber boot ont o pr opeller sh aft.
(5) Push togeth er pr opeller sh aft. P ay a tten tion to
alignm ent ma rkings for insta lla tion posit ion.
(6) Ensur e rubber seal is correctly insta lled an d
attach new collar clamps.
(7) In st all propeller shaft.
VA PROPELLER SHAFT 3 - 11
To Next Page