INSTALLATION
(1) In st all the h ydraulic con trol unit into t he ru b-
ber moun ts (Fig. 17).
(2) Reconnect t he bra ke lines to th e h ydraulic con-
trol unit (Fig. 17). Do not mix up the brake lines.
Tighten t he lines to 16 N·m (142 in. lbs.)
(3) Reconnect the mu ltiplug to t he control module
(Fig. 17).
(4) Reconnect t he gr ound cable on th e battery.
(5) Bleed t he brake system.
(6) Check t he fluid in the reservoir and correct if
necessar y.
(7) Perfor m function test.
VA BRAKES - ABS 5 - 37
To Next Page