EasyManua.ls Logo

Dodge Sprinter 2006 - Page 846

Dodge Sprinter 2006
2315 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
INSTRUMENT PANEL
AN T EN N A CABLE
REMOVAL
(1) Disconn ect and isolate the battery nega tive
cable.
(2) Remove the A-pillar trim (Refer to 23 - BODY/
INTERIOR/A-PILLAR TRIM - REMOVAL).
(3) Remove the portion of the headliner over the
front seat passen gers (Refer to 23 - BODY/INTERI-
OR/HEADLINER - REMOVAL).
(4) Disconn ect t he anten na and electr ical con nec-
tions n ear the windshield.
(5) Remove the glove box (Refer to 23 - BODY/IN-
STRUME NT PANE L/GLOVE BOX - RE MOVAL).
(6) Remove the radio (Refer to 8 - ELE CTRICAL/
AUDIO/RADIO - REMOVAL).
(7) Cut both ends of existing ca ble close to t he
instr umen t pa nel (F ig. 2).
INSTALLATION
(1) In sert new cable through glove box open ing to
the r adio opening in the in strument panel.
(2) Route ca ble up th e A-pillar and connect to th e
anten na body a nd cable.
(3) Connect th e antenna and electr ical connect ions
near the windshield.
(4) Attach antenn a ca ble to instr umen t panel wir e
harness.
(5) In st all glove box (Refer to 23 - BODY/INSTRU-
MENT PANEL/GLOVE BOX - INSTALLATION).
(6) In st all t he headliner (Refer to 23 - BODY/IN-
TERIOR/H EADLINER - INSTALLATION).
(7) In st all th e A-pilla r trim (Refer to 23 - BODY/
INTERIOR/A-PILLAR TRIM - INSTALLATION).
(8) In st all th e radio (Refer to 8 - ELECTRICAL/
AUDIO/RADIO - INSTALLATION).
(9) Connect the batt ery n egat ive cable.
RADI O
REMOVAL
(1) Disconn ect and isolate the battery nega tive
cable.
(2) Usin g special tool 9241 or equivalent , insert
one in to each slot on th e face of th e radio (Fig. 3).
(3) Disconn ect wir e h arness connector and an tenn a
from radio.
INSTALLATION
(1) Connect wire harness conn ector and antenna to
radio.
(2) Position ra dio to in strument panel and push
into place.
(3) Connect batt ery n egat ive cable.
SPEAK ER
REMOVAL
(1) Disconn ect and isolate the batt ery cable.
(2) Remove the A-pillar trim (Refer to 23 - BODY/
INTERIOR/A-PILLAR TRIM - REMOVAL).
(3) Remove speaker gr ill (Fig. 4).
Fig. 2 INSTRUMENT PANEL ANTENNA CABLE
Fig. 3 RADIO
1 - SPECIAL TOOL 9241
2 - RADIO
3 - RETAINING TAB
8A - 2 AUDIO/VIDEO VA

Table of Contents

Related product manuals