EasyManua.ls Logo

Dodge Sprinter 2006 - Page 967

Dodge Sprinter 2006
2315 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
(3) Usin g han d pressure, push the socket plate
gent ly and even ly into th e inn er rear pillar mou nting
hole un til both la tch tabs are fully engaged (F ig. 39).
(4) If t he vehicle is so equ ipped, reinstall th e trim
onto t he inside of the r ight or left rear corner pillar.
(5) Reconnect t he battery negative cable.
REAR T U RN LAM P BU LB
REMOVAL
(1) Disconn ect and isolate the battery nega tive
cable.
(2) If the vehicle is so equipped, remove th e trim
from the inside of th e right or left rear corner pillar.
(3) From in side the vehicle, use han d pressure to
pu sh the two lat ch ta bs towa rd th e center of the tail
lam p unit socket plate an d pull the socket pla te
st raight ou t from the inner rear pilla r (Fig. 41).
(4) Pull the socket plat e a way fr om the in ner rear
pillar fa r enou gh to access the turn signal la mp bulb
(Fig. 42).
(5) Remove the tu rn sign al lamp bulb from the t ail
lam p socket pla te.
INSTALLATION
(1) In st all the tu rn signa l lamp bulb into t he tail
lam p socket pla te (Fig. 42).
(2) Align the socket pla te with the moun tin g hole
in the inne r re ar p illar.
(3) Usin g han d pressure, push the socket plate
gent ly and even ly into th e inn er rear pillar mou nting
hole un til both la tch tabs are fully engaged (F ig. 41).
(4) If t he vehicle is so equ ipped, reinstall th e trim
onto t he inside of the r ight or left rear corner pillar.
(5) Reconnect t he battery negative cable.
REPEAT ER LAM P BU LB
REMOVAL
(1) Disconn ect and isolate the battery nega tive
cable.
(2) Remove t he sm all or lar ge st yle repeater la mp
unit fr om its m ounting location, but do not discon-
nect it from the veh icle wire harn ess. (Refer to 8 -
ELECTRICAL/LAMP S/LIGH TING - E XTERIOR/RE-
PEATER LAMP - REMOVAL).
(3) Remove t he bulb holder from the lens (sm all
type) (F ig. 43), or th e lens from the lamp housin g
(lar ge type) (Fig. 44).
Fig. 41 Tail Lamp Socket Plate Remove/Install
1 - SOCKET PLATE
2 - INNER REAR PILLAR
3 - LATCH TAB (2)
Fig. 42 Tail Lamp Bulb Remove/Install
1 - BRAKE/PARK LAMP BULB
2 - BACKUP LAMP BULB
3 - TURN SIGNAL LAMP BULB
4 - SIDE MARKER LAMP BULB
5 - TAIL LAMP SOCKET PLATE
VA LAMPS/LIGHTING - EXTERIOR 8L - 23

Table of Contents

Related product manuals