The X Axis Drive Assembly
DSX™ System Service Manual 7-49
3 Remove each of the three M4X16 cap head screws (one at a time), apply Loctite
222, reinstall, and tighten.
4 Remove the X Drive Encoder Pulley Alignment Tool.
5 Attach the mounting plate, which is part of the Encoder (419010000), to the
bearing boss using the Encoder Mounting Jig (DSXFIX015) and three M1.6X6
Pan Head Screws (303800106).
Note: Ensure that the mounting plate is centralized around the pulley
idler shaft.
6 Continue by mounting the encoder (see Replacing the Encoder on page 7-44).
To Next Page
Loading...
