Preface
Preface
The purpose of this manual is to enable a qualified field service engineer to carry out routine
maintenance and minor repairs on the DYNEX Technologies DSX™ Automated ELISA
System. In general, the service engineer is expected to make repairs, replace modules and
replace electromechanical subassemblies. Printed circuit boards and a few other components
are typically replaced as major subassemblies.
This manual is provided to complement the DSX™ Automated ELISA System Operator’s
Manual (Part No. 91000060). In some instances, references will be made to the Operator’s
Manual.
In most instances, the supplier of the reagent kit will install the unit. Detailed installation
information is provided in Chapter 2 of the Operator’s Manual.
Defective subassemblies may be returned to DYNEX Technologies or your DYNEX
Technologies distributor, where comprehensive repair facilities are available.
The service engineer should contact the local DYNEX Technologies service office for
additional information.
DSX™ System Service Manual i
To Next Page
Loading...
