GE HEALTHCARERAFT LOGIQ™ S7 EXPERT/PRO
DIRECTION 5460683, REVISION 3 DRAFT (JUNE 25, 2014) SERVICE MANUAL
3-54 Section 3-13 - Configuring Connectivity
NOTE: Reboot the system to activate any changes saved from this page.
Subnet Mask
Type the subnet mask address. NOTE: The Subnet Mask is an IP address filter that eliminates
communication/messages from network devices of no interest to your system.
Default Gateway Type the default gateway address.
Network Speed
Select the network speed (Auto Detect, 10Mbps/Half/Full Duplex, or 100 Mbps/Half/Full Duplex/
1000Mbps/Auto-negotiate)
Table 3-21 IP settings
Preset Parameter Description
To Next Page
Loading...
