GE HEALTHCAREDRAFT LOGIQ™ S7 EXPERT/PRO
DIRECTION 5460683, REVISION 3 DRAFT (JUNE 25, 2014) SERVICE MANUAL
Chapter 3 - Setup Instructions 3-23
3-7-2-3 During a normal boot, you may observe
A.) Power is distributed to Peripherals, Operator Panel (control panel), Monitor, Front-End and
Back-End Processor.
B.) The Back-End Processor and rest of the scanner starts with the sequence listed in following steps:
1.) “Boot Screen” is displayed.
2.) Back-End Processor is turned ON and starts to load the software.
3.) The Start Screen (LOGIQ™) is displayed on the monitor.
4.) Start-up progress bars indicating software loading procedures, are displayed on the monitor,
as shown in Figure 3-12. and Figure 3-12 below.
Figure 3-12 GE Healthcare wallpaper with progress bar (R1.x.x)
To Next Page
Loading...
