GE LOGIQ S7 Pro - Removal Procedure - LCD Touch Panel Assy

GE HEALTHCAREDRAFT LOGIQ™ S7 EXPERT/PRO
DIRECTION 5460683, REVISION 3 DRAFT (JUNE 25, 2014) SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-59
8-13-3-6 Removal Procedure - LCD Touch Panel Assy
1.) Remove connector (Marked in picture below).
2.) Remove 9 screws around LCD Touch Panel Assy.
3.) Slowly lift LCD Touch Panel Assy from OP Panel.
Figure 8-51 LCD Touch Panel Assy
8-13-3-7 Removal Procedure - Sub Board Assy
1.) Remove connector, marked below.
2.) Remove 5 screws from Sub Board Assy.
3.) Slowly lift board from OP Panel.
Figure 8-52 Sub Board Assy