GE HEALTHCAREDRAFT LOGIQ™ S7 EXPERT/PRO
DIRECTION 5460683, REVISION 3 DRAFT (JUNE 25, 2014) SERVICE MANUAL
Chapter 4 - Functional Checks 4-13
4-3-3-2 Sleep Mode Check (R1.x.x)
NOTE: This procedure assumes systems is already up and running.
1.) Press the ON/OFF button (see: Figure 4-12) on the control panel. Following dialog appears.
Figure 4-12 Power OFF User Interface
2.) Select the Sleep button. The system performs sequence to go to SLEEP mode.
NOTE: System resumes when user press Power ON/OFF switch. Boot time is about 90 seconds.
!! WARNING:
Sleep mode is not intended to replace the shutdown process.
The system should be fully shutdown every day.
!! CAUTION:
You need to wait at least one minute after the monitor blacks out before unplugging the pwer
cable. The system is still in the process of going into Sleep Mode after the monitor blacks out.
To Next Page
Loading...
