GE LOGIQ S7 Pro - Installation Procedure

GE HEALTHCAREDRAFT LOGIQ™ S7 EXPERT/PRO
DIRECTION 5460683, REVISION 3 DRAFT (JUNE 25, 2014) SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-125
2.) Draw the cabinet out of the frame Assy.
3.) Remove the Color printer cables. (refer to Section 3-6-3)
4.) Unscrew four screws and pull put the Color printer.
Figure 8-143 Remove the Color printer
8-29-2-1-4 Installation Procedure
1.) Parts to be installed in reverse order on removal.
8-29-2-1-5 Functional Check
Test 1: Print an image by pressing the button P2 on the operator panel. (P2 key should be
configured correctly)
Verify1: - Verify that image can be printed.
Verify2: - Verify that printed image has no distortion as compared the image on screen.
Figure 8-142 Drawing out the Mid cabinet