GE LOGIQ S7 Pro - Customer Granting Full Remote Access Permission to GE Service Technician; If GE Service Technician Requests Remote Access Permission

GE HEALTHCARERAFT LOGIQ™ S7 EXPERT/PRO
DIRECTION 5460683, REVISION 3 DRAFT (JUNE 25, 2014) SERVICE MANUAL
7-16 Section 7-5 - Remote Access to Service Platform
7-5-4 Customer Granting Full Remote Access Permission to GE Service Technician
7-5-4-1 If GE Service Technician requests Remote Access Permission
If a GE Service technician requests remote access to your LOGIQ™ S7 Expert/Pro scanner, following
“InSite Notification” appears on the systems s creen.
1.) Enable “Disruptive Mode” feature by confirming YES
.
NOTE: If the customer does not wish to have diagnostics running at the time of the request, they select NO
.
A message is sent back to the OLC or FE that “Disruptive Mode” is not enabled.
Figure 7-11 Insite Notification
select [Yes] to enable
“Disruptive Mode” feature