GE HEALTHCAREDRAFT LOGIQ™ S7 EXPERT/PRO
DIRECTION 5460683, REVISION 3 DRAFT (JUNE 25, 2014) SERVICE MANUAL
Chapter 1 - Introduction 1-1
Chapter 1
Introduction
Section 1-1
Overview
1-1-1 Purpose of Chapter 1
This chapter describes important issues related to safely servicing the LOGIQ™ S7 ultrasound system.
The service provider must read and understand all the information presented in this manual before
installing or servicing a unit.
1-1-2 Purpose of Service Manual
This Service Manual provides installation and service information for LOGIQ™ S7 Ultrasound Scanning
System and contains the following chapters:
1.) Chapter 1 - Introduction: Contains a content summary and warnings.
2.) Chapter 2 - Site Preparation: Contains pre-installation requirements.
3.) Chapter 3 - Setup Instructions: Contains setup and installation procedures.
4.) Chapter 4 - Functional Checks: Contains functional checks that are recommended as part of the
installation, or as required during servicing and periodic maintenance.
5.) Chapter 5 - Components and Functions (Theory): Contains block diagrams and functional
explanations of the electronics.
6.) Chapter 6 - Service Adjustments: Contains instructions on how to make available adjustments.
7.) Chapter 7 - Diagnostics/Troubleshooting: Provides procedures for running diagnostic or related
routines.
8.) Chapter 8 - Replacement Procedures: Provides disassembly procedures and reassembly
procedures for all changeable Field Replaceable Units (FRU).
9.) Chapter 9 - Renewal Parts: Contains a complete list of field replaceable parts.
10.)Chapter 10 - Care & Maintenance: Provides periodic maintenance procedures.
Table 1-1 Contents in Chapter 1
Section Description Page Number
1-1
Overview
1-1
1-2
Important Conventions
1-3
1-3
Safety Considerations
1-7
1-4
Electromagnetic Compatibility (EMC)
1-13
1-5
Customer Assistance
1-14
To Next Page
Loading...
Need help?
General
