GE LOGIQ S7 Pro - Page 169

GE HEALTHCAREDRAFT LOGIQ™ S7 EXPERT/PRO
DIRECTION 5460683, REVISION 3 DRAFT (JUNE 25, 2014) SERVICE MANUAL
Chapter 5 - Components and Functions (Theory) 5-13
Serial Port 4
Configuration
Enable
Hardware Monitor
CPU Fan
Fan control Auto
External Fan
Fan control Auto
Serial Port Console
redirection
COM1
Console redirection Disabled
COM2
Console redirection Disabled
Intel ICC
Use Wdog Tmr w/ICC
Disabled
Unused clocks off
Enable
Lock ICC registers
Static only
Clock spread spectrum
New SSC spread /0/01% 50
CPU PPM Configuration
CPU DTS
Enable
EIST
Enable
Turbo Mode
Disable
CPU C3 report
Disable
CPU C6 report
Disable
CPU C7 report
Disable
ACPI T State
Disable
Bios Menu : Chipset
PCH-IO configuration
LAN Configuration
PCH LAN Controller Enable
Launch PXE OpROM Disable
Wake On Lan Disable
SATA Configuration
SATA Controller Enable
SATA mode selection AHCI
SATA test mode Disable
OROM UI delay 2 second
Aggressive LPM
support
Enable
SATA controller
Speed
GEN3
HDA Configuration
Auto
USB Configuration
xHCI Pre-Boot driver Disable
xHCI Mode Auto
Table 5-6 BIOS Default (R2.x.x or later)