GE LOGIQ S7 Pro - Page 172

GE HEALTHCARERAFT LOGIQ™ S7 EXPERT/PRO
DIRECTION 5460683, REVISION 3 DRAFT (JUNE 25, 2014) SERVICE MANUAL
5-16 Section 5-3 - Power ON Sequence
PEG state Auto
Detect Non-Compliance device Disabled
De-emphasis control -3.5dB
PEG Link Power Saving Disabled
Memory configuration
DIMM profile Default DIMM profile
Memory frequency Auto
ECC support Disabled
Max TOLUD Dynamic
MRC Fast boot Enable
Memory Remap Enable
Memory Alias Check Disabled
GT-Power
management control
RC6(Render standby) Enable
RC6+(Deep RC6) Enable
Bios Menu : Boot
Setup Prompt
Timeout
1
Bootup Numlock
State
On
Quiet Boot Disabled
New HDD Priority Low
Bootmenu type Device based
GateA20 Active Upon request
Option ROM
message
Force Bios
Interrupt 19 capture Disabled
Boot option #1 HDD
Boot option #2 DVD
Bios Menu : Security
Administrator
Password
User Password
* GE Password : polaris
Bios Menu : Save & Exit
Save Changes and Exit
Discard changes and Exit
Save changes and Reset
Discard Changes and Reset
Save Changes
Table 5-6 BIOS Default (R2.x.x or later)