iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
87
Display operating mode of the station, remote or local, and NAT
or NAPT.
Remote: R/NAPT, R/NAT, R/NAP, R
Local remote: LO/NAPT, LO/NAT, LO/NAP, LO Local,
L/NAPT, L/NAT, L/NAP, L
The system will employ layer 2 switching over the LAN to
communicate with the linked station if set OFF. If set ON, the
system will employ ARP (Address Resolution Protocol) to
determine the device's IP address, if required, and communicate
using IP.
Normally, iPECS IP devices register using multi-cast packets.
When separated from the system, that is when the device is
remote, unicast is used.
A specific Codec type can be configured for the station.
The system uses the codec defined for the system
To Next Page
Loading...
