iPECS UCP600 - Green Mode; Green Mode Activation - PGM 500; Green Mode Time Setting - PGM 501

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
270
4.3.13 GREEN MODE
The system can disable the power of a Digital Phone or SLT (Single Line Telephone) installed in the system at
night or during holiday mode. The power On/Off can be controlled by Web Admin manually or automatically
according to the assigned power On/Off time.
4.3.13.1 Green mode activation – PGM 500
It is applied for SLIB, DSIB, and HYIB. Regarding the exact board related to the terminal, refer to iPECS eMG
Hardware Description and Installation Manual.
PROCEDURE:
GREEN MODE ACTIVATION
PRESS FLEX KEY (1-4)
Press the [PGM] button and dial 500.
Press the Flex button, 1 ~ 4. For the desired setting, refer to Table
3.3.13.1-1.
Use the dial pad to enter the required data. Refer to Table 3.3.13.1-1.
Press the [Save] button to save any changes.
Table 3.3.13.1-1 GREEN MODE ACTIVATION (PGM 500)
BTN
ATTRIBUTE/DISPLAY
DESCRIPTION
RANGE
DEFAULT
1
POWER SAVE USAGE
(1:EN/0:DIS) : DISABLE
Enable or Disable power usage.
0: Disable
1: Enable
DISABLE
2
POWER ON/OFF
(1:ON/0:OFF) : ON
Power ON/OFF manually all of the
stations in Power Save used board.
0: OFF
1: ON
ON
3
POWER SAVE MODE
PRESS SLOT BTN (F1-F6)
Enables or Disables Power Save
Usage Mode of each board.
Flex button
1-6
4
POWER CURRENT STATE
CHECK SLOT BTN (F1-F6)
Display the current status of board
power ON/OFF.
Flex button
1-6
4.3.13.2 Green mode time setting – PGM 501
It is applied for SLIB, DSIB, and HYIB. Regarding the exact board related to the terminal, refer to iPECS eMG
Hardware Description and Installation Manual.
PROCEDURE:
GREEN MODE TIME
ENTER WEEK DAY NO (1-7)
Press the [PGM] button, dial 501, and enter the day from 1 to 7 by dial
pad (Ex.1).
(MON) GREEN MODE TIME
F1:ON TIME F2:OFF TIME
Press the desired Flex button 1 or 2.
Press the Flex button, 1 ~ 2. For the desired setting, refer to 3.3.13.2-1.
Use the dial pad to enter the required data. Refer to Table 3.3.13.2-1.
Press the [Save] button to save any changes.