iPECS UCP600 - CO Call Rerouting - PGM 252

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
252
4.3.9.14 CO Call Rerouting – PGM 252
The system can reroute the incoming call to CO. If the called number is matched with compare digits of Table
252, the call is routed to the Rerouting number.
PROCEDURE:
CRR ATTRIBUTE
PRESS FLEX KEY (1-3)
Press the [PGM] button and dial 252.
Press the desired Flex button; refer to Table 3.3.9.14-1.
Use the dial-pad to enter the appropriate data.
Press the [Save] button to store the data entry.
Table 3.3.9.14-1 CALL REROUTING ATTRIBUTES (PGM 252)
BTN
ATTRIBUTE/DISPLAY
DESCRIPTION
RANGE
DEFAULT
1
ENABLE CRR
(1:ON/0:OFF) : OFF
Enable CRR
0: OFF
1: ON
OFF
2
INIT CRR
PRESS [Save] KEY
Initialize all data
3
CRR ATTRIBUTES
ENTER BIN NO (000-169)
If PGM 252-BTN1 is set ‘ON,’ BTN3 is
available. (Ex. enter the bin number
000)
000-169
4
CRR TABLE 000
PRESS FLEX KEY (1-4)
Press the desired Flex button, refer to
Table 3.3.9.14-2
Flex button
1-4
Table 3.3.9.14-2 CRR TABLE ATTRIBUTES (PGM 252)
BTN
ATTRIBUTE/DISPLAY
DESCRIPTION
RANGE
DEFAULT
1
CRR 000 COMPARE CO GRP
GRP NO (01-20) : 01
Enter group number for compare digits
in incoming.
01-20
01
2
CRR 000 RECEIVE DGTS
. . . . . .
Enter receive digits.
..
3
CRR 000 CO+TEL NUMBER
. . . . . . . . . . . . . . . . . . . . . . . . . .
Enter co group (or individual co,
access co) plus telephone number.
..
4
CRR 000 TYPE
...
N/A: press digit ‘0.’
NET TYPE: ‘1’ for transit out
DISA TYPE: ‘2’ for using DISA
0-2
N/A