iPECS UCP600 - CO Call Rerouting - PGM 252

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
204
4.4.5.37 CO Call Rerouting - PGM 252
Selecting CO Call Rerouting will display the CO Call Rerouting data entry page. Enter a valid Index range and
click [Load] to enter Call Routing data. Click the [Save] button after changing Value.
Figure 4.4.5.37-1 CO Call Rerouting
CO Call Rerouting establishes routing for CO/IP calls with a specified caller id on CO/IP Lines from a specified
group. The rerouting sends calls out over another CO/IP Line or group, a network destination, a DISA call, or
to another station. The incoming CO group and compare digits determine if the call should be rerouted, and
the destination is determined by the CO code and Telephone number, which is dialed when the incoming
group and compare digits are matched. The routing type determines if the call is routed normally (N/A) or if the
call is routed over a network or employs DISA. The example CRR chart is as below
Index
Incoming CO group
Compare Code
CO Code + Tel number
Routing Type
0
1
454
88005123456
N/A
1
2
456**
8901123456
N/A
2
1
42*555
9123456
N/A
3
5
353
8901123456
NET Type
4
5
401
DISA Type
 Index 0: If an incoming call on a CO/IP Line from a group has digits “454,” then seize CO 5 and send
digit 123456.
 Index 1: If an incoming call on a CO/IP Line from group 2 has digits “456**,” then seize CO group 1
and send digit 123456.
 Index 2: If an incoming call on a CO/IP Line from group1 has digits “42*555,” then seize the first CO/IP
Line and send digit 123456.
 Index 3; if an incoming call on a CO/IP Line from group 5 has digits “353,” then seize CO group 1 and
send digit 123456 as a transit-out call over the Network.
 Index 4: If an incoming call on a CO/IP Line from group 5 has digits “401,” then activate DISA and
await digits from the caller.