iPECS UCP600 - Page 217

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
203
Table 4.4.5.36-1 System Call Routing Attributes
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
Scenario Priority
Each scenario can be assigned a priority. The highest priority
scenario meeting the criteria is used to route the call.
0-9
(Highest
priority)
Scenario Active
A scenario must be active to be employed. If not active, the
scenario is ignored.
ON
OFF
OFF
Scenario VMID
A Voice Mail Id can be associated with the scenario for routing
to a Voice Mailbox.
Voice mail
ID
Scenario COS
If DISA is active for the scenario, the COS can be assigned for
the call.
0-11(COS level)
Refer to
description
0
Scenario DISA
Active
The scenario can employ DISA for the incoming call routing.
OFF/
ON
OFF
Scenario ICM Group
The scenario can route calls to a specific Tenancy group.
eMG80/100:0-15, eMG800:0-32, UCP:0-100
Refer to
description
0
Scenario Zone No.
A zone can be assigned so that only CO calls to a CO/IP Line
in the Zone will route based on the scenario.
0-32
0
Scenario Start CO
and End CO
This field defines a range of CO/IP Lines that will employ in the
scenario.
eMG80/100:0-74, eMG800:0-600, UCP:0-998
Refer to
description
0
Scenario Group: this
is used for scenario
group by attendant.
Scenarios can be group allowing the Attendant to select a
group of scenarios to route calls.
 eMG80/100: Group number(01~15/ 00: unused),
 eMG800: Group number(01~32/ 00: unused),
 UCP: 0-100
Refer to
description
0
Zone Holiday
A Zone can be assigned for routing calls using the scenario
during Holiday periods defined for the Zone.
0-32
0