iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
316
4.4.9.19 Dummy Dial-Tone Digit Table
Selecting Dummy Dial-Tone Digit Table will display the Dummy Dial-Tone Digit data entry page. Click the
[Save] button after changing Value.
Figure 4.4.9.19-1 Dummy Dial-Tone Digit Table
When digit conversion is programmed, the CO line is seized after digit conversion is completed. Therefore the
user cannot hear the CO dial tone from PX until completing digit conversion. For this case, a dummy dial tone
can be programmed. Pressing one pre-programmed digit (‘0–9’, ‘*,’ ‘#,’ X’) will provide a CO dial tone to the
user regardless of CO line seizure.
To Next Page
Loading...
