iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
340
4.4.12.4 T-NET FoPSTN table -PGM 333
Selecting the T-NET FoPSTN Table will display the data entry page. Enter an index range, then click [Load] to
modify the data. Click the [Save] button after changing Value.
Figure 4.4.12.4-1 T-NET FoPSTN table
The Fail-over function allows the systems in the T-NET environment to complete calls between systems over a
PSTN (analog or digital) line should the WAN connection to the CM fail. A CO gateway Module must be
registered to the LM for local CO services. Users may call others in the normal manner, and the call is routed
over CO facilities to the remote CM. When calls are directed to a DID line at the receiving system, the system
will select a line from the assigned CO Group and dial the Tel Number with the station number dialed as the
trailing digits.
Table 4.4.12.4-1 Fail Over to PSTN ATTRIBUTES
Station numbers are associated with the remote system. A range
can be indicated by using “*” to indicate the range. Example: 21*
covers 210 to 219 or 2100 to 2199.
This field defines the CO Group of the local system that will be used
to place calls to the stations entered in the Fail Over Numbering
Plan above, should WAN failure occur.
eMG80/100:1~20, eMG800:1~200, UCP:1~200
This field defines the telephone number the system should dial to
place a call to the stations entered in the FO Numbering Plan,
should WAN failure occur. An “*” may be entered as a wild card to
indicate insertion of the dialed station number.
To Next Page
Loading...
