iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
310
4.4.9.15 Voice Mail Dialing Table - PGM 234
Selecting Voice Mail Dialing Table will display the Voice Mail Dialing data entry page. Click the [Save] button
after changing Value.
Figure 4.4.9.15-1 External Voice Mail Dialing Table
When an external Voice Mail system is used that connects to an SLT port, a digit sequence must be defined
for the system to signal various call characteristics to the Voice Mail system. The external Voice Mail uses the
sequences to determine appropriate announcements or further call routing. The Table permits the definition of
digits as either a prefix or suffix to other digits (station number for mailbox identification). Sequences are
defined for such call characteristics as Put Mail, Get Mail, No Answer call, etc., as described in the following
table.
Code to send when the voice mail is to receive a call to
record a message. [Put Mail]
When you enter the Digit, the Digit means are
P: Pause, D: DND, F: Flash
Code to send when the voice mail is to playback a
recorded message.[Get Mail]
When you enter the Digit, the Digit means are
P: Pause, D: DND, F: Flash
To Next Page
Loading...
