iPECS UCP600 - Idle Line Selection - PGM 121

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
83
4.4.2.12 Idle Line Selection - PGM 121
The selecting Idle Line Selection will display the Idle Line Selection data input page. Enter a valid Station
range and click [Load] to enter the Idle Line Selection data. Check the appropriate radial button and enter the
value for the Idle Line Selection. Click the [Save] button after changing Value to apply.
Figure 4.4.2.12-1 Idle Line Selection
When a station goes to an off-hook condition (lifts handset or presses [SPEAKER] button), the system
normally provides an intercom dial tone.
In place of dial tone, the station can be programmed to access a CO Line, CO/IP Group, or call a Station or
Station Group as described in Table 4.4.2.12-1 when the station goes off-hook.
The Idle Line Selection (Prime-Line) can be either immediate or delayed after going off-hook. The
immediate/delay selection is based on the Hot/Warm assignment in ‘Common Attributes - Prime-Line.’
Table 4.4.2.12-1 IDLE LINE SELECTION TYPE & VALUE
TYPE
DESCRIPTION
No Selection
Returns Intercom dial tone.
Flex Button
The flex button activates the Flex button as if pressed.
CO Line
CO/IP path seizes CO line.
CO/IP Group
CO/IP Group seizes CO line from the CO/IP Group.
Station/Net
The station calls the assigned station.
Station group
The Station group calls the assigned station group.
Station speed
Station speed calls the assigned station speed.
System speed
System speed calls the assigned system speed.