iPECS UCP600 - Dect Attributes - Pgm 491

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
374
4.4.16.2 DECT ATTRIBUTES - PGM 491
Selecting the DECT Attributes returns the DECT ATTRIBUTES input page. Click the [Save] button after
changing Value.
Figure 4.4.16.2-1 DECT ATTRIBUTES
DECT Attributes define functions associated with the DECT equipment and operation as shown in the
following table.
Table 4.4.16.2-1 DECT Attributes
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
Auto Call
Release
If enabled, when the other party of an active internal call
disconnects, the DECT terminal returns to idle.
OFF
ON
OFF
Base Fault
Alarm
If enabled, DECT Base station alarms are sent to the Attendant.
Disable
Enable
Disable
Chain Fault
Alarm
If enabled, alarms are sent to the Attendant indicating a fault in
the link between WTIM modules. This feature is only for UCP.
Disable
Enable
Disable
Handover
Sensitivity
The user can control the handover sensitivity of GDC-500H only.
(Normal or Strong)
If this value is changed, all WTIBs will restart.
Normal
Strong
Normal