iPECS UCP600 - Inter Zone Attribute - PGM 441

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
354
4.4.13.8 Inter Zone Attribute – PGM 441
Selecting the Inter-Zone Attribute returns the data input page. Enter the desired Source and Destination Zone
number range and click [Load]to assign Zone characteristics. Click the [Save] button after changing Value.
Figure 4.4.13.8-1 Inter-Zone Attributes
Inter Zone Attributes define RTP packet relay treatment for communications between devices in different
Zones.
Table 4.4.13.8-1 INTER-ZONE ATTRIBUTES
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
Codec Type
It assigns the codec employed by devices in the Zone.
System Codec, G.711, G.723.1, G.729, G.722
Refer to
description
NA
RTP Relay
Rule
Assigns when to use the packet relay function between Zones.
With “If Need,” the MPB will automatically determine when to
use packet relay, while “RTP Relay Group” will always
implement packet relay for RTP packets between the Zones.
If need, Always not, Forced to do
Refer to
description
If need
RTP Relay
Device
Utilization
Assigns how to employ the Source and Destination VoIP
channels. The assigned Source channels may be used for both
sides of the communication or separately only for a device in the
Source Zone. The Destination channels are then used as
backup channels or only for devices in the Destination Zone.
For Both Side, Separated(SRC to DEST)
Refer to
description
For Both side