iPECS UCP600 - Page 369

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
355
Table 4.4.13.8-1 INTER-ZONE ATTRIBUTES
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
Src RTP Relay
Device Slot
Seq.
The Sequence number is associated with the VoIP channels in
the Source Zone that handle Packet Relay.
Sequence
Number
Dest. RTP
Relay Device
Slot Seq.
The Sequence number associated with the VoIP channels to
handle packet relay for the Destination Zone is defined. When
Utilization is Separate, the channels are used for devices in the
destination Zone. Otherwise, they are used as a backup for both
sides.
Sequence
Number
Max Inter-Zone
connection
This field determines the maximum Inter-Zone connections
between the source zone and destination zone. When this value
is set to 0, there is no limit on the number of connections
between the zones.
eMG80/100:0-140, eMG800: 0-1200, UCP:0-2400
Refer to
description
0
Use Firewall IP
If this option is set to ON, System uses the Firewall IP of the
VoIP board for RTP relay between Zones. But, if this option is
OFF, the System uses the Local IP of the VoIP board for RTP
relay between zones.
OFF
ON
ON