iPECS UCP600 - Dect Attributes - Pgm 4913

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
279
4.3.18 3.3.18 DECT ATTRIBUTES — PGM 4913
DECT Attributes define functions associated with the DECT equipment and operation. Generally, the entry will
turn the feature ON (enable) or OFF (disable).
PROCEDURE:
DECT ATTRIBUTES
PRESS FLEX KEY (1-4)
Press the [PGM] button and dial 491.
Press the Flex button for the desired Attribute; refer to Table 3.3.18-1.
Use the dial pad to enter the required data.
Press the [Save] button to store the data entry.
Table 3.3.18-1 DECT ATTRIBUTES (PGM 491)
BTN
ATTRIBUTE/DISPLAY
DESCRIPTION
RANGE
DEFAULT
1
AUTO CALL RLS
(1:ON/0:OFF) : OFF
If enabled, when the other party of an
active internal call disconnects, GDC-
450H/480H/500H returns to idle.
0: OFF
1: ON
OFF
2
BASE FAULT ALARM
(1:EN/0:DIS) : DISABLE
If enabled, DECT Base station (GDC-
600BE) alarms are sent to the Attendant.
0: Disable
1: Enable
Disable
3
CHAIN FAULT ALARM
(1:EN/0:DIS) : DISABLE
Not used.
0: Disable
1: Enable
Disable