iPECS UCP600 - Page 120

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
106
Table 4.4.3.3-1 BOARD BASE ATTRIBUTES
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
IP Address
Device IP address
Read-only
IPv6 Address
Device IP v6 address
Read-only
Router IP
Address
Enter the Default gateway (router) IP address associated with
the selected devices.
IP Address
Device Codec
Type
Select the CODEC type for each device.
G.711, G.723.1, G.729, G.722, SYSTEM CODEC
Refer to
description
SYSTEM
CODEC
Firewall IP
Address
Enter the Firewall IP address of the selected devices.
0.0.0.0
RTP Packet
Relay Firewall IP
Address
Enter the Firewall IP address associated with the Remote Phone
or Gateway if there is a dual broadband connection for SIP
trunks and Remote phones (using a VOIB/VOIM).
0.0.0.0
RTP Security
SRTP implements AES (Advanced Encryption Standard) for
packets between other devices with RTP Security enabled. To
reduce bandwidth use or to use an external VPN, this parameter
must be OFF.
OFF
ON
ON
TNET Enable
When a module or station is to be connected in a Centralized
Control network (TNET), the device must be enabled for TNET
operation.
eMG80/100:ON, eMG800:OFF, UCP: OFF
OFF
ON
Refer to
description
T38 Enable
FAX over IP Lines is supported when T38 mode is ON.
OFF
ON
OFF
USE Board IP for
SIP
When the VoIP channels of a VOIB/VOIM are used for SIP, such
as a SIP Trunk, the IP address of the VOIB/VOIM must be used
for the SIP messages (ON).
OFF
ON
OFF
T38 Port Usage
The TCP/IP port employed for T38 packets is negotiated, and
the system can allow the port to be the same as or different from
the preceding Voice packets. The system can also employ NAT
to determine the port.
Different from Voice, Same as Voice, NAT Triggering
Refer to
description
Different
from Voice
RFC2833
Payload
Payload value for RFC2833
0~127
101
RFC2833
Volume
Volume(Gain) of RFC2833 payload
0~36(-dB)
10
RFC2833
Redundancy
Sending time of end packet of RFC2833
1~8
4
Web Connection
Setting for Web connect.
OFF
ON
ON
Telnet
Connection
Setting for Telnet connect.
OFF
ON
OFF