iPECS UCP600 - Page 137

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
123
Table 4.4.4.9-1 MATM ATTRIBUTES
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
2W or 4W
For E&M Lines, this value should be set as 2 wire or
4wire to match the line.
2W/
4W
4W
DLY Start Timer
It is the timer value for analog signaling.
0~255
6
Wink Timer
It is the timer value for analog signaling.
0~255
6
SND ANS Timer
It is the timer value for analog signaling.
0~255
6
SND RLS Timer
It is the timer value for analog signaling.
0~255
13
SND RING ON Timer
It is the timer value for analog signaling.
4~255
20
SND RING OFF Timer
It is the timer value for analog signaling.
4~255
40
SND RING RPT CNT CO
It is the timer value for analog signaling.
0~255
8
SND RING RPT CNT RD
It is the timer value for analog signaling.
01~20
2
CO Ring STOP Timer
It is the timer value for analog signaling.
0~255
30